The Xantrex (formerly Trace Engineering) sine wave inverters provide sinewave output with high efficiency, high surge and low idle current. With three micro-processors and bi-directional power topology, it is over 90% efficient through most of its load range, peaking at 96% efficiency. The new “soft start” system allows the inverter to run heavier loads with improved reliability.

The SW inverters can be programmed to perform automatic generator start and stop, automatic load sensing and generator support, and includes protective circuitry which guards against downtime. Indicators show over-current, over-temperature, short circuit, and low and high battery voltage conditions.所有Xantrex SW逆变器包括一个内置的、完全automatic, three-stage battery charger, designed for maximum charging and minimum generator time and fuel. Two year warranty, ETL listed to UL standards. SW Series dimensions are: 15” x 22.5” x 9”.

Applications

Off Grid:Widely used throughout the world as a primary source of AC electricity, the SW offers sine wave,utility grade output power, high capacity battery charger, high surge current ability (inrush current), and easy installation.

Backup Power:When the utility fails, the SW Series instantly supplies AC power to critical loads.When utility power returns, it can automatically recharge your batteries in preparation for the next power interruption.

SW II Series Inverter / Charger

Name	Battery Volts	AC Volts / Hz	Continuous Watts	Charge Amps	Ship Weight
SW4024	24	120/60	4000	120	111 lbs.
SW4048	48	120/60	4000	60	111 lbs.
SW5548	48	120/60	5500	75	143 lbs.

Call toll-free(877) 297-0014for more information or to order.

SW Series Datasheet

Other options for the SW4024, SW4048 and SW5548:

SWCA Communications Adapter-The SWCA serial communications adapter allows for remote set-up, adjustment, troubleshooting and monitoring of up to eight SW series inverters from a personal computer.Click here for more info.

SWRC Remote Control-Designed for use with SW and PS series inverter/chargers, the SWRC is a full-function remote control with backlit LCD display. The remote control comes with a standard 25’ (7.5 m) cable or a 50’ optional (15 m) cable.

SWI/PAR-The SWI/PAR is used to connect two identical SW or PS Inverters in parallel to produce twice the output power at the same voltage.

SWI-The SW Interface is used to stack two identical SW or PS Inverters in series. This will provide twice the voltage and power output in a 3-wire, 120/240 VAC, 60 Hz configuration, The SWI is only available for use with North American SW series inverters.

Call toll-free(877) 297-0014for more information or to order.